Sisältöä ei voida näyttää
Chat-sisältöä ei voida näyttää evästeasetusten vuoksi. Nähdäksesi sisällön sinun tulee sallia evästeasetuksista seuraavat: Chat-palveluiden evästeet.
EvästeasetuksetAbstract
A Ka-band dual input, three stack power amplifier (PA) is designed and fabricated using 22nm CMOS FDSOI. The PA output matching is implemented with a transformer-based combiner, which allows tuning the load with bias and input drive settings. The PA shows maximum output power, gain, one dB output power compression point (P 1dB ) and power added efficiency (PAE) of 19.5dBm, 11.5dB, 14.1dBm and 17%, respectively, measured at 29.5 GHz. Measured amplitude to phase modulation (AM-PM) stays at very low level, below 0.7° up to P1dB and below 2.6° up to P3dB. With a 100 MHz 64-QAM OFDM signal the PA achieves 8% error vector magnitude (EVM) and -28dBc adjacent channel leakage ratio (ACLR) at 6.3dBm and 7.6dBm output channel power, respectively.
Ulkoasu |
application/pdf |
---|---|
Kieli |
englanti |
Asiasanat |
Sisältöä ei voida näyttää
Chat-sisältöä ei voida näyttää evästeasetusten vuoksi. Nähdäksesi sisällön sinun tulee sallia evästeasetuksista seuraavat: Chat-palveluiden evästeet.
Evästeasetukset